Configuring the Display of Call Destination for Incoming Calls
Use the following procedures to configure the display of call destination for
incoming calls on the IP Phones.
Configuration Files
For the specific parameter you can set in the configuration files, see Appendix A, the section,
Destination for Incoming Calls"
Limitations
The following are limitations of this feature:
•
Any call destination name exceeding the screen length is truncated by the
phone.
•
The CT cordless handsets do not support this feature.
•
Page scrolling every 3 seconds is hard-coded and not configurable.
41-001160-04 Rev 02, Release 2.5
Note: As shown above, when both call diversion and call destination are enabled,
the formation displays to the phone's screens in the following order:
Screen 1
Caller info
Screen 2
Call destination
Screen 3
Call diversion
on
page
A-185.
Configuring Operational Features
Operational Features
"Display of Call
5-295