Autodial Settings - Aastra 9143i Series Administrator's Manual

Autodial Settings

You can configure the following Autodial settings.
Parameter In
IP Phone UI Aastra Web UI
N/A Autodial Number
(Global and
Per-Line)
N/A Autodial Timeout
(Global and
Per-Line)
N/A Use Global Settings
(Per-line
configurations only)
41-001160-04 Rev 02, Release 2.5
Parameter in
Configuration Files
sip autodial number
sip lineN autodial
number
sip autodial timeout
sip lineN autodial timeout
N/A
Parameters in
Globally or on a per-line basis,
specifies the SIP phone number that
the IP phone autodials when the
handset is lifted from the phone
cradle. An empty (blank) value
disables autodial on the phone.
For more information, see Chapter 4,
"Autodial Settings"
Globally or on a per-line basis,
specifies the time, in seconds, that the
phone waits to dial a preconfigured
number after the handset is lifted from
the IP phone cradle.
If this parameter is set to 0 (hotline),
the phone immediately dials a
preconfigured number when you lift
the handset. If this parameter is set to
a value greater than 0, the phone
waits the specified number of seconds
before dialing the preconfigured
number (warmline) when you lift the
handset.
Default is 0 (hotline).
For more information, see Chapter 4,
"Autodial Settings"
For each line, this parameter specifies
to use the global autodial settings of
"Autodial Number" and "Autodial
Timeout".
For more information, see Chapter 4,
"Autodial Settings"
Administrator Options
Administrator Level Options
Description
on page 4-107.
on page 4-107.
on page 4-107.
3-71