Configuring a Park/Pickup Key Using Aastra Web UI
For 8 and 11-Line LCD phones, you configure a Park and/or Pickup key at
Operation->Softkeys and XML. You enter a key label, and value for a specific
line on the phone. The default state of the Park configuration is "connected". The
default state of the Pickup configuration is "idle, outgoing".
The CT handsets use the park/pickup configuration enabled at
Operation->Handset Keys in the Aastra Web UI. If Park or Pickup are enabled
on more than one line on the base unit, the CT handsets use the first
programmable configuration.
For example, if line 1 and line 6 are configured for park, the CT handsets use the
configuration set for line 1 to park a call.
On 3-Line LCD phones (not applicable to 6751i), you configure a Park and/or
Pickup key at Operation->Programmable Keys, and then enter the appropriate
value and line.
Park/Pickup Call Server Configuration Values
Server
Aasterisk
Sylantro
BroadWorks
ININ PBX
*Leave "value" fields blank to disable the park and pickup feature.
Use the following procedure to configure the Park/Pickup call feature using the
programmable configuration method and the Aastra Web UI.
41-001160-04 Rev 02, Release 2.5
Note: Applicable values depend on the server in your network (Asterisk,
BroadWorks, Sylantro, ININ PBX. See the table below for applicable
values.
Park Values*
70
*98
*68
callpark
Configuring Operational Features
Operational Features
Pickup Values*
70
*99
*88
pickup
5-241