Aastra 9143i Series Administrator's Manual page 396

IP Phone Administrator Guide
Operational Features
Configurable Status Code on Ignoring Incoming Calls
When a user presses the "Ignore" key on the phones during an incoming call, the
phone rejects the incoming call with a status code of "486 Busy Here". The IP
phones allow an administrator to configure this status code. You can configure the
status code using the configuration files only.
Use the following parameter to configure a status code when ignoring incoming
calls:
• sip ignore status code
Configuring Status Codes on Ignoring Incoming Calls
You can use the following procedure to set the status code sent in the response
when a user presses the "Ignore" key.
Configuration Files
For the specific parameter you can set in the configuration files, see Appendix A, the section,
on Ignoring Incoming Calls"
5-90
Note: Valid status codes are based on RFC3261.
on page A-169.
"Status Code
41-001160-04 Rev 02, Release 2.5