Table of Contents
Advertisement
Minilog
When torch switch is pressed gas flow starts. When you release the torch switch current goes
through upslope to Hot Start or Soft Start -current depending on adjustments and by pressing
shortly again to welding current. After another short press it goes to Minilog operation, and
you can select from two current levels: the welding current and the Minilog current. You can
move from one to the other by quickly pressing the torch switch. Press the torch switch for
one second, release it and current goes to downslope and tail arc. Arc is cut by short press of
the switch.
4T-lOg
When torch switch is pressed current goes to search arc; after the switch is released current
goes to welding current within the upslope time. When the switch is pressed again, current
goes to downslope and then to the tail arc. Current stops when the switch is released.
synergetic quick pulse
Press the PULSE button twice and the synergetic light turns on. Pulse parameters are
calculated automatically when average welding current is selected. Other pulse selections are
not necessary.
long pulse
Long pulse method gives you the possibility to adjust all pulse parameters (pulsing frequency,
pulse ratio, pulse current and pause current). You can also adjust the welding current, in which
case you receive a new pulse current value. Pulse ratio and pause current percentage remain
constant. When you adjust the pulse ratio, pulse current or pause current, the new average
welding current value is shown on the display.
spot welding function
The function can be used both in 2T and 4T mode. Enter the spot duration by pressing arrow
button, and when the led is lit you can choose the spot time needed by turning the pulse
potentiometer.
Tig -Micro tack welding function (MicroTack™)
You can select the Micro Tack function with a long press of the SPOT arrow button. When this
function is activated, the machine automatically enables the DC- welding mode, 2T switch mode
and contact ignition. Also the upslope and downslope values are set to zero and SPOT led starts to
blink. To inactivate the Micro Tack you press briefly the same arrow button.
This function can be used with HF ignition and 4T mode. The duration of the spot weld can be
adjusted by pressing Quick Setup button and selecting a value in the range 1-200 ms. The Micro
Tack welding current can be adjusted with the control knob, when the welding current led is on.
3.2.3 saving welding settings
ACX panel has 10 memory channels for user settings. The selections are made in the MEMORY
field. Not only welding parameters but also function selections can be saved in the memory.
MMA welding values can also be stored in memory channels. Proceed as follows:
1.
Press MEMORY button and if the SET light starts blinking the channel is free. If a channel is in
use, the ON light will light up. Press again, and the SET light will be continuously lit.
2.
Select memory channel by pressing CH button.
3.
Select the parameters and press SAVE button.
4.
Press MEMORY button twice. ON led is lit.
5.
Start welding.
If the saved settings need to be adjusted the led has to be moved from ON to SET position in
order to select parameters. Press the SAVE button.
When the memory function is in OFF state (no lights on) it is also possible to save the currently
used panel parameters by pressing SET/SAVE, by choosing channel ja by pressing SET/SAVE
again. Channel is cleared if MEMORY and CH buttons are pressed simultaneously in SET mode.
EN
15
Hide quick links:
Advertisement
Table of Contents
