User Manual
Ascom i75 VoWiFi Handset
11
Push-to-Talk Conference Call
Note: The Push-To-Talk function requires a Multi Point Control Unit (MCU), handsets
programmed with PTT settings (from the PDM) and that groups have been created in the
system.
The push-to-talk (PTT) function can be described as a group/conference call. A PTT session
can be triggered from the system, by an alarm or by a user that sends an invitation to a
PTT group from the handset.
Select
Figure 8. Example of groups in a PTT list
A PTT invitation can either be accepted or rejected by pressing a soft key. All group
members that have accepted the PTT session, can listen to the conversation which by
default starts in loudspeaking mode. If one of the group members wants to get in contact
with the others, he simply presses and holds the Mute button to open the microphone.
More than one handset can press the Mute button and start transmitting at the same
time.
The function must be assigned to a Soft key, a Hot key or a Service. Refer to
Soft key
on page 47,
44.
11.1 Send an Invitation to a PTT Group
1
Press the preprogrammed Soft/Hot key or select the Service. The invitation is sent
immediately to the preprogrammed PTT group.
11.2 Accept a PTT Conference Call
1
Press "Accept" to be connected to the PTT session. Default the handset will start in
inverted mute and loud-speaking mode, but it can be configured differently in the
received PTT message.
2
Press and hold the Mute button to open the microphone for transmitting. The
microphone is muted again when the Mute button is released.
11.3 Reject a PTT Conference Call
1
Press "Decline" to reject the PTT session. The handset will return to the previously
shown screen and the PTT message will be stored in the message list.
2008-11-10/ Ver. D
Figure 22.
PTT
Assembly group 1
Assembly group 2
Guards section A
Cancel
15.5.9 Edit a Hot key
on page 48, or
15.4.3 Edit a Service
TD 92319GB
15.5.8 Edit a
on page
27
Need help?
Do you have a question about the i75 VoWiFi and is the answer not in the manual?