Manually Adjusting The Audio Level Of The Front Microphone - Sony HDW-730 Operation Manual

Note
When you select that the MIC LEVEL control is linked with the LEVEL
(CH-1/CH-2) control(s), if the MIC LEVEL control is turned fully
counterclockwise to 0, the audio signal input to AUDIO IN CH-1/CH-2
connectors cannot be recorded. Before adjusting the audio level using the
LEVEL (CH-1/CH-2) controls, confirm the setting of the MIC LEVEL
control.
Manually adjusting the audio level of the front
microphone
You can adjust the audio level input from the front microphone
connected to the MIC IN connector, which is to be recorded in audio
channels CH-1 and CH-2.
Notes
• When 1 and 2 are not displayed under the audio channel level
meters, the CH-1/2 / CH-3/4 switch is set to the CH-3/4 position. Set
this switch to CH-1/2.
• If the XLR connection automatic detection mode is set to ON, when
the cables are connected to the AUDIO IN CH-1/CH-2 connectors, the
camcorder detects the connection to the AUDIO IN CH-1/CH-2
connectors. Thus, the AUDIO IN switch is internally reset to REAR
and the audio signals input to the AUDIO IN CH-1/CH-2 connectors
are automatically selected.
Before adjusting the audio level of the front microphone, confirm that
no cables are connected to the AUDIO IN CH-1/CH-2 connectors.
Or set the REAR XLR AUTO to OFF on the VTR MODE 1 page of
the MAINTENANCE menu.
Chapter 4 Adjustments and Settings for Recording
4
(Continued)
4-31