Adjusting The Exhaust Gas Volume - Yamaha FZ1-N Service Manual

Make sure that the vacuum pressure is
within specification.
10. Stop the engine and remove the measuring
equipment.
11. Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE
CABLE FREE PLAY" on page 3-9.
Throttle cable free play
(at the flange of the throttle
grip)
3.0–5.0 mm (0.12–0.20 in)
12. Install:
• Synchronizing hoses
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
• Rider and passenger seat
Refer to "GENERAL CHASSIS" on page 4-
1.
EAS20600

ADJUSTING THE EXHAUST GAS VOLUME

NOTE:
Be sure to set the CO density level to stan-
dard, and then adjust the exhaust gas volume.
1. Turn the main switch to "OFF" and set the
engine stop switch to "ON".
2. Simultaneously press and hold the
"SELECT" and "RESET" buttons, turn the
main switch to "ON", and continue to press
the buttons for 8 seconds or more.
NOTE:
"dI" appears on the clock LCD.
3. Press the "SELECT" button to select the
CO adjustment mode "Co" "1" or the diag-
nostic mode "dI".
4. After selecting "Co", simultaneously press
the "SELECT" and "RESET" buttons for 2
seconds or more to execute the selection.
NOTE:
The selected cylinder number appears on the
clock LCD.
• To decrease the selected cylinder number,
press the "RESET" button.
• To increase the selected cylinder number,
press the "SELECT" button.
5. After selecting the cylinder, simultaneously
press the "SELECT" and "RESET" buttons
for 2 seconds or more to execute the selec-
tion.
6. Change the CO adjustment volume by
pressing the "SELECT" and "RESET" but-
tons.
NOTE:
The CO adjustment volume appears on the
tripmeter LCD.
• To decrease the CO adjustment volume,
press the "RESET" button.
• To increase the CO adjustment volume,
press the "SELECT" button.
7. Release the switch to execute the selec-
tion.
3-8
ENGINE