Yamaha FZ1-N Service Manual page 251

10. Install:
• Pull lever
NOTE:
Install the pull lever with the "O" mark facing
toward lower side.
11. Install:
• Clutch cover
• Clutch cover gasket
NOTE:
• Install the pull rod so that the teeth a face
towards the rear of the vehicle. Then, install
the clutch cover.
• Apply oil onto the bearing.
• Apply molybdenum disulfide grease onto the
pull rod.
• When installing the clutch cover, push the
pull lever and check that the punch mark "a"
on the pull lever aligns with the mark "b" on
the clutch cover. Make sure that the pull rod
teeth and pull lever shaft pinion gear are
engaged.
• Tighten the clutch cover bolts in stages and
in a crisscross pattern.
12. Tighten
• Clutch cover bolts "1"
Clutch cover bolt
12 Nm (1.2 m·kg, 8.7 ft·lb)
• Clutch cover bolt "2"
Clutch cover bolt
12 Nm (1.2 m·kg, 8.7 ft·lb)
LOCTITE®
NOTE:
Tighten the clutch cover bolts in a stages and
in a crisscross pattern.
13. Adjust:
• Clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" on page 3-14.
5-53
CLUTCH