Yamaha FZ1-N Service Manual page 171

4. Tighten:
• Lower handlebar holder nuts
Lower handlebar holder nut
32 Nm (3.2 m·kg, 23 ft·lb)
5. Install:
• Clutch lever holder "1"
• Clutch cable
NOTE:
Align the slit in the clutch lever holder with the
punch mark "a" in the handlebar.
6. Install:
• Left handlebar switch
NOTE:
Align the projections "a" on the left handlebar
switch with the hole "b" in the handlebar.
7. Install:
• Handlebar grip "1"
• Grip end "2"
Grip end
26 Nm (2.6 m·kg, 19 ft·lb)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Apply a thin coat of rubber adhesive onto
the left end of the handlebar.
b. Side the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EW2D1007
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
NOTE:
There should be 1–3 mm (0.04–0.12 in) of
clearance "a" between the handlebar grip and
the grip end.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
8. Install:
• Throttle grip "1"
• Throttle cable hoousing "2"
• Throttle cables
• Grip end "3"
NOTE:
Align the projections "a" on the throttle cable
housing with the hole "b" in the handlebar.
9. Install:
• Right handlebar switch
4-46
HANDLEBAR