Yamaha FZ1-N Service Manual page 81

1. Fuel tank
2. Fuel tank drain hose
3. Fuel tank breather hose
4. Clip
5. Air filter bracket
6. 3 way connector
7. Hose
8. Fuel hose
9. Damper
10.Collar
11.Fuel tank bracket
12.O-ring
13.Fuel pump
A. Hook the cover pawl to the fuel tank
bracket.
B. The knob of the clip can be positioned in
any direction.
C. Assemble the two folding sections of the
collar flange as shown in the illustration.
D. Fit the knob of the clip as shown in the
illustration.
E. Fit the white paint section of the hose
pointed downward.
F. Pass the hose through the fuel tank
bracket clamp. There should be no bend of
the hose between the fuel tank nipple and
clamp.
G. Align the projection part with the pump
seat nut.
H. Fit the orange double lock side to the pump
side.
I. Fit the black double lock side to the engine
side.
J. The fuel tank bracket shall not run on the
tank flange as shown in the illustration.
K. Fit the O-ring with its lip pointed upward.
L. Tightening sequence
M. Fuel piping connector attachment direc-
tions. (fuel pump side) Always perform the
connection/disconnection works by hand.
Do not use tools.
N. 1. Insert the connector until the click sound
is heard and check that the connector does
not come off. Make sure that no foreign
matter is caught in the sealing section. (It is
prohibited to wear the cotton work gloves
or equivalent coverings.)
O. This part works as a dropout stopper.
P. 2.After Step [N] as above is finished, check
that the connector is completely attached
by sliding the double lock (orange part) on
the connector as shown in the illustration
and seeing if it touches firmly or not.
2-54
CABLE ROUTING