14.2.4 Important Safety Instructions
Note: Only relevant to 1.9 GHz products.
Before using your telephone equipment, you should always follow basic
safety instruction to reduce the risk of fire, electrical shock and injury to
persons, and damage to property.
1. Read and understand all instructions
2. Follow all warnings and instructions including those marked on the prod-
uct
3. Unplug this product before cleaning. Do not use liquid cleaners or aero-
sol cleaners. Use damp cloth for cleaning
4. Do not install the telephone equipment in the bathroom or near a wash
bowl, kitchen sink, or laundry tub, in a wet basement, or near a swim-
ming pool
5. Slots or openings in the equipment are provided for ventilation to protect
it from over-heating. These openings must not be blocked or covered.
6. The product should be operated only from the type of power source indi-
cated on the instructions. If you are not sure of the type of power sup-
ply, consult your dealer or local power company.
7. Do not overload wall outlets and extension cords as this can result in fire
or electrical shock.
8. Never push objects of any kind into this product through cabinet slots as
they may touch dangerous voltage points or short out parts that could
result in fire, electrical shock, or injury. Never spill liquid of any kind into
this product.
9. To reduce the risk of electrical shock or burns, do not disassemble this
product. Opening or removing covers may expose you to dangerous
voltages, dangerous electrical current, or other risks. Incorrect reassem-
ble can cause electrical shock when the appliance is subsequently used.
If the product need repair, consult your dealer.
10. Refer servicing to qualified service personnel.
11. Avoid using telephone during an electrical storm. There may be a risk
of electrical shock from lightning.
12. Do not use the telephone to report a gas leak in the vicinity of the leak.
13. Do not place the base or charger near microwave ovens, radio equip-
ment, or non-ground connected televisions.
These appliances may cause electrical interference to the base or handset
14. The charger must be placed on a hard, flat surface and connected to a
functional 120 volt AC power source depending on the country of use.
15. This telephone will not operate in the event of a blackout. Please keep a
backup phone for emergencies.
16. Installation must be performed in accordance with all relevant national
wiring rules.
17. Plug acts as Disconnect Device - The socket outlet to which this appara-
tus is connected must be installed near the equipment and must
always be readily accessible.
VoIPon
www.voipon.co.uk
74
sales@voipon.co.uk
Tel: +44 (0)1245 808195
Fax: +44 (0)1245 808299
Need help?
Do you have a question about the 5020 and is the answer not in the manual?