Pre-Installation Functional Check - LEGRAND VADDIO RoboSHOT 30E-M Installing

Basic connections for conferencing
This diagram shows a basic conferencing configuration.
The PoE+ switch is not required. You can connect the camera to the network and to power using the mid-
span power injector included with the camera.

Pre-installation functional check

If you're installing the camera where it's hard to reach, you may want to verify functionality before you
install it.
1. Connect the camera.
2. Start a call.
3. Verify that you can select the camera, and that it sends video.
If the camera turns on and sends video, continue with the installation.
If it does not, do these things:
Make sure all cables are plugged in and fully seated.
n
Try a different power outlet.
n
Connect the camera using known good cables.
n
If these steps don't solve the problem, contact Vaddio Technical Support at (+1) 763-971-4400
or 800-572-2011.
Installation Guide for the RoboSHOT 30E-M PTZ Camera
5