Advertisement
Engineering Mode
Press STOP and then SPEED UP to enter the Engineering Mode. You can press ENTER/MODE to
switch setup screens, or press STOP+SPEED UP to return to Standby Mode. The table below
shows the sequence of the setup screens.
Engineering function
Press and Hold STOP and then Speed Up buttons
until the console beeps and the display changes.
(incline window shows software version)
(lower right corner shows software version date)
Press Enter / Mode (TR1200i only)
Guard automatically pauses the unit if it detects the
treadmill is not being walked on. Use Up Down buttons
Press Enter / Mode to show Roller diameter
TR800: roller diameter in inch
TR1200i: roller diameter in mm
Press Enter / Mode to set up the units of measurement
in Metric (SI) or in English (EN).
Press Speed/Incline or Up/Down to change
Press Enter / Mode to set up Calendar
Calendar Operation:
Press Enter / Mode for Distance
This is the total distance the treadmill has been run
in Miles or Kilometers depending on what mode the
treadmill is in.
Press Enter / Mode for Workout Time
This is the total number of hours the treadmill
has been used.
Press Enter/Mode again to return to the standby mode.
44
Information on screen
ENG.
100
MODE
I - G
ROL
En or Si
CALE
NDER
0
DI
S
0
HOUR
2009.07.09
On
599
On
000
000
Advertisement
