Engineering Mode - LifeSpan TR3000i Owner's Manual

Engineering Mode

Press STOP and then SPEED UP to enter the Engineering Mode. You can press ENTER/MODE to
switch setup screens, or press STOP+SPEED UP to return to Standby Mode. The table below
shows the sequence of the setup screens.
Engineering function
Press STOP and then Speed Up to enter the
Engineering Mode.
(incline window shows software version)
Press Enter / Mode
Guard automatically pauses the unit if it detects the
treadmill is not being walked on. Press Speed/Incline
Up/Down buttons
Press Enter / Mode to show Roller diameter
Press Enter / Mode to set up the units of measurement
in Metric (SI) or in English (EN).
Press Speed/Incline or Up/Down to change
Press Enter / Mode to set up Calendar
Calendar Operation:
Press Enter / Mode for Distance
This is the total distance the treadmill has been run
in Miles or Kilometers depending on what mode the
treadmill is in.
Press Enter / Mode for Workout Time
This is the total number of hours the treadmill
has been used.
Press Enter/Mode again to return to the standby mode.
44
Information viewed on screen
Engineering Mode
150
2009.06.18
Intelli-Guard On
Roller
Select the units
En or Si
Set Calendar On
Total Distance
0
Total Hours
0
625
000
000