Advertisement
Step 2: Handlebar Assembly
A. Rotate the handlebars down so they are positioned on top of the handlebar posts.
Secure the right and left handlebars to the support post using the 2 M8 x70L screws (B)
provided in the hardware bag.
Note: Make sure that the wires on both sides are not pinched
in-between the handlebars and the handlebar post.
B. Rotate the console bracket (8) up in the back until it reaches its normal operating position.
This will cause the console support tube to rotate in the frame.
C. Place the left outside handlebar cover (9) next to the inside handlebar cover (pre-attached)*.
allowing the plastic ridge to sit in the groove of the blue rubber ring. Secure these three
parts together using the self-tapping screws (C).
Repeat this process on the other side with the right outside handlebar cover (10).
B
9
blue rubber ring
10
8
C
X
*Note: the TR800 inside handlebar
cover is not pre-attached and
comes in two pieces.
TR800
12
Advertisement
