Table of Contents
Advertisement
Satellite setup
Satellite setup
number for each LES in the list – number 1 will appear first in the
default LES list.
These lists can only be read and changed when the terminal is in
contact with the NCS – receiving the signal from the NCS. And the
allowed LES operators can only be marked when PIN2 is known –
see section 6.7.4 Security.
To edit/insert and delete entries in these lists require knowledge
of PIN2 pin-code (MES PIN2 if no SIMM card is inserted and SIMM
PIN2 if SIMM card is inserted). Normally PIN2 is known by the ISP.
This is due to the fact that the ISP may only have agreements with
specific LES operators.
The Std def LES
Std def LES, Std pref LES
Std pref LES and Std all LES
Global Area Network is in the Stand Alone mode where no NCS is
available and one of the LES's take over. In these menus it is
possible to setup the default, preferred and allowed LES in the
same way as when the Global Area Network is in normal
operation.
The Area
Area menu has got the following list of possible choices:
•
Automatic
•
AORW
•
AORE
•
IOR
•
POR
•
Spare 1
•
Spare 2
•
Spare 3
•
Spare 4
The selection is marked with an *. If Automatic is selected, the
terminal will determine the area, if the antenna is correctly
pointed towards the corresponding satellite, as described in
section 4.2 Pointing the antenna. The selection is changed by
choosing an area and then pressing C.
13Jun00
13Jun00
Basic functions
Basic functions
Std all LES are used if the
Page 6-7
Page
6-7
Advertisement
Table of Contents
