Power Computing PowerWave 604 User Manual page 65

4.
Make sure that the driveÕs power cable is plugged in and seated Þrmly.
5.
Make sure that each device in the internal SCSI chain has its own unique
SCSI ID: the primary hard drive should be set to ID 0 and the CD-ROM is
normally set to 3. (See ÒSet SCSI IDÓ on page 35.)
6.
Make sure there are no internally-terminated devices in the in the middle of
the SCSI chain. The only internally-terminated device on the internal SCSI
chain should be the pre-installed primary internal hard drive.
7.
Replace the computerÕs cover, re-connect system components, and restart
the computer.
If these steps do not correct the problem, contact the drive manufacturer or Power
Computing Technical Support at 1-800-708-6227 for assistance.
For Technical Support, Call 1-800-708-6227
Upgrading Your Computer
PowerWave 604 UserÕs Guide
45