Power Computing PowerWave 604 User Manual page 61

7.
Unscrew the two screws holding the metal bay cover, if there is one, in
front of the drive bay and set the plate and screws aside where you will be
able to Þnd them later.
If you are installing a drive that does not use removable media, you will need to replace
this plate after you have installed the drive.
Note:
tower drive may have a metal plate without screws, which is attached by two thin
strips of metal. To remove that type of plate, simply bend it back and forth several
times until it comes loose, and remove it.
Install the drive
Once you have prepared the drive (see ÒPrepare the drive,Ó starting on page 35) and the
computer (see ÒPrepare the computer,Ó starting on page 37), you are ready to install the
drive.
Note:
mate them. If a cable is very hard to connect, examine it carefully to make sure you
have it oriented so that it Þts the connector it goes onto. Once cables are connected,
make sure they are snug.
For Technical Support, Call 1-800-708-6227
metal bay cover
screws
The slot under the ßoppy drive on the desktop model and the top slot on the
Connectors are keyed, which means that there is only one correct way to
Upgrading Your Computer
PowerWave 604 UserÕs Guide
41