Built-In Shower Control; Solid Wall Or Stud Partition (Using Securing Brackets - Mounting Off Front Face) - Mira DISCOVERY Installation And User Manual

Built-in Shower Control

1. Solid Wall or Stud Partition
(Using Securing Brackets - Mounting off Front Face)
1.1 Determine the route for the hot and
cold supply pipework and for the
outlet pipework. When connecting
to the BIV Shower Fittings it is
recommended that the outlet be
positioned above and to one side of
the Shower Control. This is to prevent
the Flexible Hose from obstructing
the Shower Controls.
1.2 Remove the two Securing Screws
(retain for later use) and remove the
Shower Control from the Building-in
Shroud.
1.3 Mark the position of the Shower
Control using the Building-in Shroud
as a guide.
1.4 Mark the routes for the hot and
cold supply pipework at 135 mm
centres.
Falling Supplies: For falling supplies
loosen the grubscrew on each Elbow
using the 2.5 mm Hexagon Key
(supplied). Remove the Elbows and
install on opposite sides. Secure the
Elbows with the Grubscrews.
Caution! Do not overtighten.
Note! Make sure that the Filter
Plugs are positioned to the front
(i.e. Hexagonal Key facing forward).
1.5 Mark the route for the outlet
pipework.
Note! The Outlet Elbow should be
sited above the Shower Control and
on the right or left, as site dictates.
1.6 Remove the plasterboard and brick
work to a minimum depth of 62 mm.
Alternative Pipe Layouts
Outlet Pipe BIV
Hot Inlet
62 mm Min
19
Outlet Pipe BIR
Outlet Pipe BIV
Cold Inlet
Shower Control
6 mm Min
Finished Wall
Finished Wall
Surface
24 mm Max
Finished Wall