Mira DISCOVERY Installation And User Manual page 13

8. The water supplies to this product must be isolated if the product is not to be
used for a long period of time. If the product or pipework is at risk of freezing
during this period they should also be drained of water.
9. All pipework must be checked for leaks before the product installation is
completed. The mixer should be pressurised and the inlet & outlet connections
inspected. If the mixer is dismantled
during installation or servicing then
upon completion the product must
be inspected to ensure there are no
leaks
10. Decide on a suitable position for the
mixer. The position of the mixer and
the Shower Fittings must provide a
minimum gap of 25 mm between the
spill-over level of the shower tray/bath
and the handset (refer to illustration).
This is to prevent back-siphonage. For
further information on the installation
of your Shower Fittings, refer to the
Fittings Installation and User Guide.
Note! Only use Shower Fittings
recommended by the manufacturer or supplier.
11. Do Not overtighten grubscrews as product damage may occur. Use hexagonal
key provided and hand tighten only, do not use power tools.
12. Having completed the installation, make sure that the user is familiar with the
operation of the mixer and that this guide is left with the user.
13
Hose Retaining Ring
25 mm Minimum
Spill-over Level