Mira DISCOVERY Installation And User Manual page 29

11. Rotate the Cartridge 180° to reverse the inlets to the Cartridge.
Caution! Make sure the two Cartridge Side Seals are not damaged.
12. Refit the Cartridge into the Shower Control Body, make sure that the lugs
engage in the slots in the Body.
Note! To assist in refitting the Cartridge, rotate 45° (i.e. with the inlet seals at
2 and 8 o'clock) and push into the Shower Control, then rotate to align the lugs
with the slots in the body and push fully home (refer to illustration).
Important! Make sure that the side seals do not extrude from the Shower
Control Body when pushing the cartridge in. Damage to these seals will result
in a leak from the shower outlet.
Carefully push the Cartridge into the
Shower Control Body and rotate.
13. Tighten the Brass Nut using the 'O' Key (supplied).
14. Remove the 'O' Key.
Note! If the 'O' Key has become trapped under the Yellow lugs on the
Flow Control, rotate them until the 'O' Key can be removed.
Note! The Flow Control Lugs on pre 2006 models are Black.
Caution! Make sure that the Yellow Lugs are returned to the fully clockwise
position before restoring the water supplies.
15. Restore the hot and cold water supplies and check for leaks.
16. Exposed Models Only:
a) Fit the Lever Retainer with the clips horizontal, make sure both sides locate
under the lip and rotate anticlockwise.
b) Fit the Locking Ring.
17. Built-in Models only:
a) Fit the Backplate to the Shower Control and secure with the two Securing
Screws. Make sure that the Foam Seal is fully compressed.
b) With the cutout at the bottom, slide the Concealing Plate over the Shower
Control, engage the crosses in the Concealing Plate with the square recesses in
the Backplate, and push firmly until the Concealing Plate clicks into position.
18. Refer to the section 'Installation, Control Assembly' and follow steps
8 to 12.
Cartridge Lugs
29
Slots