Extron electronics XTP T USW 103 User Manual page 27

Input/Output tab
Click the tab to open the Input/Output screen. It contains input information
Input/Output
and options to apply automatic settings to individual inputs.
Figure 14. Input/Output Tab
Input name — Displays the input name.
Signal type — Displays the signal type of each input. Input 1 is . Inputs 2 and 3 are
analog
.
HDMI/DVI
Auto-Image — Select the check box of input 1 to apply an automatic
Auto-Image
Auto-Image. When selected, Auto-Image is applied whenever there is a change in the input
sync. Auto-Image attempts to size and center the input signal based on the aspect ratio
setting.
Auto Memory — Select the check box of input 1 to enable the Auto
Auto Memory
Memory. Auto Memory recalls input and image settings for signals that have previously been
applied. When it is disabled, the XTP T USW 103 treats every newly applied input as a new
source.
HDCP authorization — Select either check box to have input 2 and 3
HDCP Authorized
report as an HDCP authorized device. If the box is not checked, the source will be blocked
from encrypting its output. This may result in some content not being passed by the source
device.
NOTE: HDCP authorization is for inputs 2 and 3 only.
XTP T USW 103 • XTP System Configuration Software 21