Connecting The Power Cord - Fujitsu PRIMERGY CX400 S1 Upgrade And Maintenance Manual

4.13

Connecting the power cord

Ê Connect the power cord to the server enclosure PSU.
Ê Connect the mains connector to an outlet on the rack's socket strip (see also
Technical Manual for the rack).
I
A phase redundancy in the power supply of the server enclosure can
be set up if two hot-plug PSUs are installed.
In this case, each of the PSUs is either connected to two different
phases or to two separate circuits of the internal power supply
network.
Ê Ensure that the indicator on the PSU lights up green.
I
For more information see section
page 208.
CX400 S1
Upgrade and Maintenance Manual
Basic hardware procedures
"Power supply module" on
73