Replacing The 3.5-Inch Hdd Sas/Sata Backplane; Required Tools; Preliminary Steps - Fujitsu PRIMERGY CX400 S1 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
7.4.2

Replacing the 3.5-inch HDD SAS/SATA backplane

Field Replaceable Units (FRU)
Average task duration: 70 minutes
Average software task duration: 5 minutes
Note on system information
The 3.5-inch HDD SAS/SATA backplane contains the Chassis ID EPROM that
contains system information like server name and model, housing type, serial
number and manufacturing data.
7.4.2.1

Required tools

Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Main steps:
●
– Phillips PH2 / (+) No. 2 screw driver, minimum length 200 mm
7.4.2.2

Preliminary steps

Perform the following procedures:
"Shutting down the server node" on page 41
Ê
"Removing the server enclosure out of the rack" on page 43
Ê
V
CAUTION!
For ALL service tasks, remove the CX400 S1 server enclosure out of
the rack and put it on a separate desk!
It is not allowed to draw the CX400 S1server enclosure partially out
of the rack.
"Removing the server node from the server enclosure" on page 48
Ê
126 Upgrade and Maintenance Manual
CX400 S1