6. When finished press [ENT] to save.
7. Press [CLR] to show the Chart page.
9.2
CREATING AN OLYMPIC ROUTE
This feature allows the starting point in a Route to be saved as the final destination point.
1. On the Chart page move the ShuttlePoint knob to the Lat/Lon of the starting Waypoint
in the Route.
2. Press [ROUTE], the starting Waypoint will be placed under the cursor.
3. Move the ShuttlePoint knob to the second Lat/Lon of the next leg in the Route.
4. Press [ROUTE]. Another Waypoint is shown under the cursor and a line joins the
starting Waypoint to the second Waypoint.
5. Repeat steps 3 and 4 until all Waypoints are entered into the Route.
6. Then move the ShuttlePoint knob to the last Waypoint and press [ENT].
7. Move the ShuttlePoint knob to highlight OLYMPIC and press [ENT]. A line joins the
starting Waypoint and the last Waypoint.
Page 72
Figure 9.1 - Route Report
Figure 9.2 - Olympic Route creation (1)
Figure 9.2a - Olympic Route creation (2)
CPF180i and CPF300i
R