Table of Contents
Advertisement
17.10.1
STC (Sensitivity Time Control)
The purpose of this selection is to filter surface noise in the water.
The STC functions reduces or eliminates Surface Clutter signals by changing the Sensitivity
of the receiver, decreasing it near the surface and gradually increasing it as the depth
increases. Its default value is SHORT for the 200kHz frequency and MID for the 50KHz
frequency. Such values are good in most conditions. However when navigating in very
shallow waters it may be necessary to switch it to OFF, while in very deep waters with a lot
of Surface Clutter it may be better to increase it to MID or LONG.
In some situations it may be necessary to adjust the STC so the sounder can read through the
surface noise and show the bottom. One indication that the STC needs to be changed is when the
display intermittently changes the depth from the correct depth to a very shallow depth.
The STC can be changed from Short, Mid, Long and Custom.
17.10.1.0
STC Length
This is the depth range which the STC operates. In custom mode it can be varied from 0FT
to 1000FT (60FT or 255FT on previous software versions). In preset mode it's value is
reported in the following table (See Par. 17.10.1.2).
17.10.1.1
STC Strength
It is the starting attenuation value of the STC. It acts by attenuating the Gain of the given
percentage value. In custom mode it can be varied from 0% to 100%. The STC effect is
maximum near the surface, to eliminate the Surface Clutter and it progressively diminishes
to 0 at the selected STC depth.
17.10.1.2
Preset values table
STC Depth (Ft)
STC Length
If in VERY SHALLOW WATER the Fish Finder display is showing a bottom or digital
readout deeper than the actual depth this situation may occur if STC is set to LONG or
MID when the bottom is shallow. This issue may be resolved by adjusting the STC value
to SHORT or even to OFF in very shallow waters.
If in DEEP WATER the Fish Finder display is showing a very shallow bottom or digital
Page 132
NOTE
Figure 17.10.1 - STC - Surface Clutter
OFF
Short
1
0
10%
Figure 17.10.1.2 - STC Preset values table
Mid
60
60
30%
R
Long
255
57%
CPF180i and CPF300i
Advertisement
Table of Contents
