The satellite image is only shown on 100NM, 50NM and 20NM scales.
To activate this function follow the procedure below:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight SATELLITE IMAGERY and press [ENT] or
move the ShuttlePoint knob to the right.
4. The menu now shows two selections, ON or OFF.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the chart page is shown.
6.0.6
Currents Prediction
The worldwide database with Tidal stream information is available with MAX C-CARDs.
When data/time is available, Tidal stream arrows are shown on the charts, indicating the
direction and strength of the Tide:
If no data/time is available from the GPS or the GPS Chart Plotter is not in Simulation mode,
the icon on the map is generic one. The color of the arrow denotes the strength of the current
as follows:
CPF180i and CPF300i
NOTE
Figure 6.0.5 - Example of Satellite Imagery on CPF300i
Figure 6.0.6 - Tidal stream arrows
Page 59
R