Table of Contents
Advertisement
2.4.3.2 Connection a VideoCamera, AIS Receiver, VHF and Autopilot
VIDEO
Camera
CPF300i
Transducer
The Input and Output baud rate for each port is set using the Advanced
Setup>In/Out Connections menu. For example if Port1 is set for AIS 38400, the
Input and Output both operate at 38400 baud.
AIS Setup
The CPF300i has to be setup to be able to receive NMEA information from the AIS receiver. When
AIS 38400 is selected the Output Port is disabled.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT2 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
2.5
BATTERY CONNECTIONS
1. The GPS Chart Plotters are supplied with a fuse and holder. This fuse should be
installed into the Black wire to protect the NMEA Output/Input circuits from becoming
damaged.
2. Connect the Red and Black wires from the GPS Chart Plotter to a 12VDC source directly
as possible.
2.6
NMEA CONNECTIONS
The GPS Chart Plotter can be connected to external devices with NMEA and display
information, examples:
· DSC VHF Radio
· Depth Sounder, Speed Log, Wind Instrument, Autopilot etc.
· Radar (USA O
· Personal Computer
Page 24
)
NLY
Optional WAAS GPS
antenna
Red
Black
Blue
Brown
Gray
Yellow
NOTE
Switch
2A
Battery
Fuse
10-35Vdc
Port 1 Input
Port 1 Output
Port 2 Input
Port 3 Output
CPF180i and CPF300i
R
-
+
VHF
AIS
PILOT
Advertisement
Table of Contents
