Engine Oil Filter Change - KYMCO Yager 200i Owner's Manual

MAINTENANCE
Engine oil filter replacment
The engine oil filter must be replaced periodically per the ser-
vice maintenance schedule (see pages 39 - 41).
1. Remove the oil dipstick 1 from the right crankcase cover.
2. Place a suitable container (drain pan) under the left crank-
case and remove the oil filter cap 2.
48
1 1 1 1 1
2 2 2 2 2
3 3 3 3 3
4 4 4 4 4
3. The oil filter 3 and the oil filter spring 4 will come out when
the cap 2 is removed. Let the engine oil drain out.
4. Discard the oil filter.
5. Make sure the oil filter cap O-ring 5 is good condition.
Only use a genuine KYMCO genuine oil filter element,
or an oil filter element of equivalent quality, on your
scooter. Using the wrong KYMCO oil filter element, or a
non-KYMCO oil filter element which is not of equivalent
quality, may cause engine damage.
6. Install the oil filter, the oil filter spring, the oil filter cap O-
ring and the oil filter cap. Torque the cap's nuts to the speci-
fied torque.
Oil filter cap nut torque:
5 5 5 5 5
2 2 2 2 2
8.6 lb-ft (12 N.m)