KYMCO Yager 200i Owner's Manual page 47

MAINTENANCE
2 2 2 2 2
3. Remove the drain bolt 2 to drain the oil.
4. Replace the drain bolt 2. Tighten it to the specified torque.
Oil drain bolt torque: 18 lb-ft (25 N.m)
5. Add the specified engine oil through the oil filler/dipstick
hole (amount is after draining).
Engine oil capacity:
Engine oil viscosity:
1 1 1 1 1
6. Wipe the dipstick 1 off with a clean cloth and reinstall
it in its hole, but do not thread it into the engine case.
Push the dip stick to the engine until it touches the case.
7. Remove the dip stick and visually inspect the oil level on
the stick. The engine oil level should be above the "L"
mark but not higher than the "F" mark. Add or remove oil
as required.
0.95 qt (0.8 L)
SAE 15W-40
F
L
45