Troubleshooting Error Codes - Laguna Bay Spas Spa Owner's Manual

"ESA":
Temperature Sensor Error.
connected and that there is no damage to the connector or the cable. If this does
not correct the problem call technical support at 877-722-4097.
"ESb":
Water Flow Sensor Error.
connected and that there is no damage to the connector or the cable. If this does
not correct the problem call technical support at 877-722-4097.
"Eob": Water Flow Sensor Error.
connected and that there is no damage to the connector or the cable. If this does
not correct the problem call technical support at 877-722-4097.
"EHH": Heater Error.
be sure the filter and filter basket are free of debris. Remove the spa cabinet and
allow the spa to cool. If this does not correct the problem call technical support
at 877-722-4097.
"EoH":
Heater Error.
be sure the filter and filter basket are free of debris. Remove the spa cabinet and
allow the spa to cool. If this does not correct the problem call technical support
at 877-722-4097.
"EPL":
Water Flow Error.
remove debris. Make sure the slice valves are locked in the "UP" position. Clean
or replace the filter. If this does not correct the problem call technical support at
877-722-4097.
"ECP":
Water Flow Error.
remove debris. Make sure the slice valves are locked in the "UP" position. Clean
or replace the filter. If this does not correct the problem call technical support at
877-722-4097.
"LLL":
Low Water Level.
your spa model. Add water if needed. If this does not correct the problem call
technical support at 877-722-4097.
'ICE": Freeze Warning. Your spa is in danger of freezing.
is below 44°F and the heater may not heat the water enough to prevent damage
to the spa. Reset the GFCI and check for normal operation. If the spa does not
resume normal operation, call technical support at 877-722-4097.
30
Topside Controls

Troubleshooting Error Codes

Check to be sure the cable is properly
Check to be sure the cable is properly
The spa is overheating. Do not enter the water. Check to
The spa is overheating. Do not enter the water. Check to
Check the suction drain covers and filter basket and
Check the suction drain covers and filter basket and
Make sure water is at the level recommended for
Check to be sure the cable is properly
The water temperature