Instructions For Filling The Spa - Laguna Bay Spas Spa Owner's Manual

Your new Laguna Bay Spa has been put through rigorous testing during the
manufacturing process. It is not uncommon that some water may remain in
the plumbing after testing and may leave spots on the acrylic finish or cabinet.
Wipe the spa and cabinet with a clean soft rag. Do not use household cleaners
that contain bleach or ammonia (cleaners that are manufactured to clean glass)
because they may have an adverse effect on the surfaces of the spa and have
a negative reaction with chemicals used to maintain water chemistry. Never
use abrasive cleaners on the cabinet, cover or acrylic surface. They may do
permanent, irreversible damage.
With the drain valve open, rinse the inside of the spa with clear water. With
the filters removed and the drain valve open, run water through the filtration
canister and jet lines until the water runs clear. This will remove any incidental
dust, dirt and debris that may have accumulated during shipping and installation.
Check to be sure the GFCI is turned off.
service or cleaning when power is applied to the spa. Each time you
remove the spa cabinet for any reason, check to be sure the GFCI is
turned off.
Never leave the spa unattended
spa.
Remove the entire cabinet panel with the sticker
PANEL FOR ELECTRICAL". In most models you will remove the panel
underneath the spa's top side control pad by removing all screws attaching the
cabinet panel to the spa frame. Check for obvious signs of damage including
loose wires or broken pipes. If you see damage inside the spa cabinet, call a
technical service associate at 877-722-4097 for assistance and repair
Hand tighten the plumbing unions
locked and in the "up" position. If the slice valves are not in the up position,
pull the "T" stem all the way up to open the slice valves. Lock the "T" stem and
attach the clip locks. The slice valves allow service to the spa without draining
water by stopping the flow of water. Never operate the spa when the slice valves
are closed. This will damage the pumps and seals. Damage that occurs because
the spa was powered on when the slice valves were closed is not covered by the
manufacturer's warranty.
With the slice valves are locked in the up position
tightened, remove the floating weir, skimmer basket and filters from the filtration
canister of your new Laguna Bay Spa.
Do not use water that has been filtered or softened.
you fill your spa.
22
Getting Started
Preparing the Spa for Use
Filling the Spa with Water
while the exterior panels or cover are off the
and check to be sure the slice valves are
Never attempt any kind of
that says "REMOVE THIS
and the unions hand
Do not use hot water when