Laguna Bay Spas Spa Owner's Manual page 20

The slice valves should always be locked in the "up" position
is applied to the spa. If the spa is allowed to operate when the slice valves are
closed it will damage the spa. Each time you change the water in the spa, you
should check to be sure the locks on the slice valves are in good condition; locks
should be replaced if they will not hold the "T"stem in the "up" position. Do not
use the spa until the locks have been replaced.
The Plumbing Unions
When you receive the spa and each time you fill the spa with water, you should
hand tighten the plumbing unions, which loosen in transit and when seasons
change. In many cases, when there is a leak inside the spa cabinet, it is from
a plumbing union that needs to be tightened. Do not use tools or overtighten
plumbing unions as you may damage the spa.
Filter Basket
Filter
assembly on a regular basis making sure the basket is free of debris and the filter
is in good condition. If the filter assembly is obstructed, flow will be restricted
and damage the spa. The manufacturer recommends that you replace the filter
every three months. To prevent air getting into your spa, you should soak new
filters in water for 30 minutes before installing.
The Suction Drain Covers
well of the spa. They are caps that cover the suction
drains that prevent debris from being sucked into
the plumbing lines. If the suction drain covers are
obstructed, flow is restricted which can damage your
spa.
It is important to check them on a regular basis
be certain they are in good condition to help prevent
20
Getting Started
connect the plumbing lines to the spa components.
The Filter Assembly
and the floating weir. Never use the spa without the filter
assembly in place because it will not only damage the spa
but is a drowning hazard. If any part of the filter basket
assembly is damaged, do not use the spa until it has been
replaced.
To remove the filter basket when filling the spa or
changing the filter,
it stops to unlock the basket. Lift the basket assembly to
remove. Lift the filter out of the filter housing. Replace
the filter, place the basket assembly over the filter housing
and turn the basket assembly clockwise until it stops and is
locked in place.
The filter basket catches large debris,
fine particulates and oil. You should check the filter
are on the sides in the foot
consists of the filter, the filter basket
turn the basket counter clockwise until
to
when power
the filter catches