Topside Controls; Operating Modes; Panel View - Laguna Bay Spas Spa Owner's Manual

AUX
When you receive your new Laguna Bay Spa, it will arrive with factory
programmed settings with the clock set to Eastern Standard Time, in Standard
Mode, with a Filtration Cycle to begin at 6 PM (18:00) and ending at 8 PM
(20:00) If the water temperature drops 3°F below the desired water temperature
you program, the heater will automatically turn on to heat the water back to
the temperature you choose.
when exiting the spa ensures optimal energy efficiency.
Standard Mode:
Std
backlighting will be blue and the LED will display "Std". While
you are using your Laguna Bay Spa, it should be in Standard Mode.
Standard Mode allows full function of Jets, filtration cycles and maintains the
water temperature to the temperature you set.
Economy Mode:
Ecn
backlighting will be green and the LED will display "Ecn". In Economy
Mode, the spa will run the programmed filtration cycles and will maintain the
water temperature within 3 degrees of the set temperature. Your spa should
put the spa in Economy Mode each time you exit the spa for optimal energy
efficiency. The pump will run on low speed when the spa is heating and will turn
off automatically when the water reaches the correct temperature.
Slp
Sleep Mode:
display will be lavender and the LED will display "Slp". Sleep Mode
should be used when you are not using your spa for long periods of time. When
your spa is in Sleep Mode, the spa will run filter cycles and will only heat when
the water temperature falls to 44°F. Sleep mode protects the spa and keeps the
water from freezing.
24

Topside Controls

99 F
1
For most users, putting the spa in economy mode

Operating Modes

When your spa is in Standard Mode, the
When your spa is in Economy Mode, the
When your spa is in Sleep Mode, the backlighting on the
16:30
Std
AUX
3
2
M
3
2
1