Fcc - Laguna Bay Spas Spa Owner's Manual

Clean the vinyl with approved, non-alcohol based cleaner.
cleaners will break down the vinyl and stitching over time.
Use only approved and recommended accessories,
DON'T:
Leave the spa exposed to the sun
cover in place. Exposure to direct sunlight, excessive rain and snow and falling
debris can cause distress to the spa's shell material.
Push or drag the spa cover.
Lift or drag the cover by using the cover lock tie
the cover by using the handles.
Place heavy objects on your spa cover.
inserts to crack.
Use sharp objects near your spa cover.
and/or plastic causing the foam inserts to become heavy and break.
Use excessive chemicals.
materials allowing the foam inserts to become heavy and break. When adding
chemicals, it's a good idea to leave the cover partially open for 20 minutes to
allow excessive chemicals to escape.
10
IMPORTANT INFORMATION
ABOUT SPA SAFETY
This will damage the cover.
Excessive chemical use breaks down the cover
FCC NOTICE
If your spa is equipped with audio or video
equipment, it has been tested and found to
comply with the limits for a class B Digital Device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, use harmful interference to radio
communications. However, there is no guarantee
that the interference will no occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment on
and off, the user is encouraged to try to correct
the interference by one or more of the following
measures:
or other elements without water or the vinyl
downs. Always lift or carry
Heavy weight loads will cause foam
Sharp objects may puncture the vinyl
Alcohol based vinyl
chemicals and cleaners.