110V Spa Installation - Laguna Bay Spas Spa Owner's Manual

Electrical Information
NFPA/70 and in compliance with Underwriters Laboratories, Inc.. This might be
used as a shut off switch, which must be installed so that it is accessible to the spa
occupants, but not within 5 feet (1.5m) of the spa.
All connections should be made using copper conductors
ONLY.
Do not use aluminum wire. Connection wires, circuit breakers,
and/or fuses, must all be sized to accommodate the Total Ampere load.
All 110 volt Laguna Bay Spas are delivered with a GFCI power cord that is
approximately 15 feet in length. Electrical service must be no farther than 15 feet
(4.5m) and no closer than 5 feet (1.5m) to the spa. There is a reset switch on the
power cord which allows you to reset power by pressing the reset button on the
plug. If service is interrupted, you must press the reset button to restore service.
The dedicated circuit must have a 20 amp GFCI in the main breaker panel
with ground wire and the correct polarity throughout the circuit. A pressure
wire connector is provided on the exterior surface of the control box, inside the
spa. This wire allows grounding between this point and any metal equipment,
reinforced concrete, metal pipe or water pipes within 5 feet (1.5m) of the spa.
The bonding wire must be solid copper wire.
Do not connect the spa using extension cords or surge protectors.
must be connected to a dedicated 110v/20a GFCI protected, grounded circuit.
This circuit must not be used by or shared with any other electrical component.
If it is connected to a shared circuit, it will overload the circuit leading to tripping
at the main breaker.
Power supplied to your Laguna Bay Spa must be a through dedicated circuit
with no other appliances, lighting, or any other electronic components powered
by this circuit. Failure to connect the spa to a breaker that is dedicated may result
in damage or failure of the equipment which is not covered by the manufacturer's
warranty.
Do not use the spa if the cord or plug is damaged.
power source and do not use until they have been replaced.
Do not apply power to the spa until it has been filled with water.
110 V INSTALLATION
The spa
Disconnect the spa from the
15