Changing Operating Modes; Setting Programming Cycles - Laguna Bay Spas Spa Owner's Manual

Pressing this button changes the modes. The LED will display the mode the spa
is currently in. Your Laguna Bay Spa is set at the factory in Standard Mode "Std".
When the spa is in Standard Mode, the backlighting on the LED will is
Std
blue and the LED will display "Std". To change from Standard Mode to
Economy Mode, press the "M" button.
The backlighting on the LED display will not change. The LED
Std
Ecn
display will STD and ECN will flash.
When the spa is in Economy Mode, the backlighting on the LED display
Ecn
will change to green. Press the "M" button once to enter Sleep Mode.
The backlighting will change to lavender and the LED will display "Slp".
Slp
To enter Standard Mode, press the "M" button.
When you receive your new Laguna Bay Spa, it will arrive with factory
programmed settings with the clock set to Eastern Standard Time, in
Standard Mode, with a Filtration Cycle to begin at 6 PM and ending at 8 PM.
You should put your spa in economy mode each time you exit the spa for
optimal energy efficiency.
The clock displays military time.
18:00 and so on). The Mode Button allows you to change the factory settings;
filtration time, filter duration, and the time on the clock.
Press and hold the "M" button for 6 seconds to enter programming mode.
no buttons are pressed for 6 seconds, the spa will exit programming mode and
resume with the programmed settings. While you are in the program menu, use
the Up or Down keys to adjust the parameters and use the "M" key to move to
the next parameter.
The changes will be saved after the confirmation of the last parameter only.
there is no key pressed for 6 seconds, the system will exit the program menu
without saving the changes.
Topside Controls

Changing Operating Modes

(Midnight is 00:00, Noon is 12:00, 6 PM is
Programming
M
M
If
If
27