Canadian Installation - Laguna Bay Spas Spa Owner's Manual

1. Rearrange or relocate the receiving antenna;
2. Increase the separation between equipment and receiver;
3. Connect the equipment into an outlet on a circuit different from the
circuit connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressed or approved by party responsible for
FCC compliance could void the user's authority to operate this equipment.
IMPORTANT CSA SAFETY INSTRUCTIONS (CANADA ONLY)
When using this electrical equipment, basic safety precautions should always be
followed, including the following:
1. Read and follow all instructions.
2. A green colored terminal or a terminal marked G, Gr, Ground, Ground
symbol * is located inside the supply terminal box or compartment.
To reduce the risk of electric shock, this terminal must be connected to
the grounding means provided in the electric supply service panel with
continuous copper wire equivalent in size to the circuit conductors that
supply this equipment. *IEC Publication 417, Symbol 5019.
3. At least two lugs marked "Bonding Lugs" are provided on the external
surface or on the inside of the supply terminal box/compartment. To
reduce the risk of electric shock, connect the local common bonding grid in
the area of the hot tub to these terminals with an insulated or bare copper
conductor..
4. All field installed metal components such as rails, ladders, drains, and other
similar hardware within 10 feet (3m) of the hot tub shall be bonded to
equipment grounding buss with copper conductors..
5. SAVE THESE INSTRUCTIONS.
IMPORTANT INFORMATION
ABOUT SPA SAFETY
11