True CS900 Owner's Manual page 24

CHAPTER 2: ASSEMBLY INSTRUCTIONS
ELLIPTICAL ASSEMBLY STEPS (continued):
Step 10: Attach Chin Bar:
a) Attach Chin Bar using 4 M8x12
bolts.
b) Attach Chin bar covers by
Chin Bar Cover
M8x12 Bolts
aligning grooves and sliding
forward.
Hardware Required (Bag 10):
4 M8x12mm Bolts
Step 11: Floor Levelers:
If necessary, adjust four levelers on bottom of machine to accommodate uneven flooring.
Step 12: Remove Protective Film from Decals:
Once Elliptical is moved into its final location, remove the protective film from the decals and from the "True" on the
lower shroud.
Optional Power Supply Installation:
*These steps are only required if this unit will be paired with a touchscreen console or 15"TFT Console.
a) Remove both right rear plastic
Buttons need to be
covers.
pried up to expose
bolts
Note:
The power supply is shipped in the
same package as the console
Rear covers removal (6
screws total)
Truefitness.com / 800.426.6570 / 636.272.7100 20