True CS900 Owner's Manual page 16

CHAPTER 2: ASSEMBLY INSTRUCTIONS
ELLIPTICAL ASSEMBLY STEPS (continued):
STEP 3 Attach Rear Step:
a) Insert the step weldment into
the rear openings making sure the
screw holes face up.
b) Using the 2 M10x50 bolts and 2
M10 nuts, attach the weldment.
c) Attach the plastic step using the
4 M5x12 stainless bolts.
Hardware Required (Bag 3):
4 M5x12 Bolts
2 M10 Nuts
2 M10X50 Bolts
STEP 4: Attach Draw Bars:
a) Slide correct drawbar onto
corresponding shaft.
b) Install, but do not tighten a M10
bolt, lock washer, and flat washers
with 17mm socket and wrench.
c) Repeat these steps for both sides.
Hardware Required (Bag 4):
2 M10 Bolts 2 Flat Washer
2 Lock Washer
d) Secure bottom of drawbars
using 4 M8x 12 bolts and 4 M8
curved washers.
e) Once all bolts are started, tighten
bottom bolts with 6mm allen
wrench and top bolts with 17mm
socket and wrench.
Hardware Required (Bag 4):
8 M8x12bolts
8 Curved
Washers
*Drawbars are labeled "L" for left and "R" for right
Truefitness.com / 800.426.6570 / 636.272.7100
M10x50 bolts
M10 Nuts
M5x12 bolts
12