True CS900 Owner's Manual page 15

CHAPTER 2: ASSEMBLY INSTRUCTIONS
ELLIPTICAL ASSEMBLY STEPS (continued):
STEP 1: Assemble Pedestal to Base (continued):
d) Remove the twist tie from the
Rubber seal and slide it up over
the weld beads to its correct
location. Make sure "Up" tab is
facing up on the rear of the
machine.
e) Connect Wires coming out of
the bottom right side of pedestal
to the corresponding wires
coming out of the frame.
STEP 2 Attach Inner Shrouds:
a) Make sure wires are tucked
away before attaching inner
shrouds.
b) Use two M4x16mm screws
and four M5x12 screws per side
to attach inner shrouds.
Hardware Required (Bag 2):
8 M5x12mm Screws
4 M5x16mm Screws
Make sure to pull
black cover over
Coax connection.
Truefitness.com / 800.426.6570 / 636.272.7100
"This side up" Tab
Rubber seal
Connect all wires
and push them
back into the
opening and out
of the way.
M4x16mm Screws
M5x12mm screws
11