Table of Contents
Advertisement
7- Installer commissioning
To enter this mode, press the button
for 10 seconds until CF01 is
displayed.
7.1 Choosing the temperature displayed (CF01)
: Temperature of the room measured by
MINOR 11
: Current set-point temperature (default mode)
Select by pressing the or buttons
confirm by pressing and releasing
the next menu.
7.2 Choosing the control sensor (CF02)
: Sensor within the casing (by
default)
: Underfloor sensor (optional)
Select by pressing the or buttons
and
, confirm by pressing and releasing
.
Passage au menu suivant.
and
. Go on to
- 10 -
7.3 Correcting the temperature measurement
(CF05)
If you notice a difference between the temperature
recorded (thermometer) and the temperature
measured by the unit, this menus allows you to
correct the difference (+/-5°C in increments of 0.1°C).
E.g. The temperature displayed is 19°C and the
temperature recorded is 20°C, so set
+1°C.
,
Make the selection by
Confirm by pressing and
releasing
Go on to the next menu.
You must wait at least 24 hours until the effect of
the correction can be observed in the room.
or
,
.
- 11 -
Hide quick links:
Advertisement
Table of Contents
