Power To Be Switched; Exiting The Installer Mode; Operation; Choosing The Operating Mode - DELTA DORE MINOR 11 Installation And User Manual

7.7 Power to be switched (CF10)
This parameter is only displayed if the
Underfloor heating mode (CF07 - § 7.5)
and the internal sensor (CF02 - § 7.2)
are selected.
: Up to 1,000 W (direct control)
: From 1,000 W to 2,300 W (direct control, by
default)
: Greater than 2,300 W (contact switch control)
Press the button several times for rapid access to
a specific menu

7.8 Exiting the installer mode

You can exit the installer mode by
pressing the button
last menu (CF09 - § 7.6 or CF10
- § 7.7) or automatically after
2 minutes without pressing any
button.
after the
- 14 -

8- Operation

8.1 Choosing the operating mode

Select the operating mode by pressing and
releasing the button repeatedly
MINOR 11 follows the mode
AUTO
requested by the programmer.
MINOR 11 regulates according to
Comfort
the Comfort set-point configured.
MINOR 11 regulates according to
Economy
the Economy set-point configured.
MINOR 11 regulates according to the
Frost
Protection Frost protection set-point configured.
OFF The heating is shut down

8.2 Set-point temperature setting

8.2.1 Set-point setting for the sensor within the
casing (selection of sensor type made §7.2)
Select the mode to set (
the button .
Use or , to make your choice (5°C to
+30°C or 5°C to 15°C for the
In Comfort mode, MINOR 11 will regulate
according to the set-point configured.
:
or ) by using
,
).
- 15 -