Operations During Rotary Mode; Category Selection; Direct Channel Selection; Manually Setting Channels Into Memory - Eclipse CD3200 Handy Reference Manual

How to operate the tuner with an optional XM satellite radio tuner connected
(U.S.A.lCANADA
only)
Operations during rotary mode
II
Turn the [VOL] button to the left or
right.
Turn to the right:
Tunes to higher channels.
Turn to the left:
Tunes to lower channels.
Category selection
The channel can be selected from among
categories such as ROCK and DANCE.
Consult the
XM
website for the details of the
categories.
II
Press the [SELECT] (Up/Down)
button for less than one second.
The category will switch in the order
shown below each time button is
pressed.
Up:
Advances to the next category.
Down:
Returns to the previous category.
Direct channel selection
The channel can be selected by inputting the
channel directly.
II
Press the [MODE] button for more
than one second.
The mode will change to the direct
channel selection mode.
2
Press the [SELECT] (Right/Left)
button to select the channel
number.
Right:
Advances to the next number.
Left:
Returns to the previous number.
I
Press the [SELECT] (Up/Down)
button to select the channel
number to be input.
Each time the button is pressed, the
channel number changes in the
following order.
OH1H2H3H4H5H6H7H
8H9HOH'"
II
Press the [ENTER) button.
Reception starts.
Manually setting channels into
memory
This section covers the storing of stations in the
memory of numbered buttons.
I
Press the [SELECT] (Right/Left)
button to tune to the channel to be
stored in the memory.
I
Select
any button, from [1] to [6],
and press it for more than two
seconds.
The tuned channel is now memorized
and set in the button selected. Repeat
the procedure to set additional
manually tuned channels into memory,
in turn, for buttons [1] to [6]. These
buttons are called the preset buttons.
~ATTENTION
•
If the vehicle's battery is disconnected (for
repairs to the vehicle or when removing the
main unit), all channels stored in memory will
be lost. In such cases, set the channels into
memory again.
89