How To Operate The Tuner; Listening To The Tuner; Tuning To A Station; Operations During Rotary Mode - Eclipse CD5030 Owner's Manual

Operation

How to operate the tuner

Operation
ATTENTION
If stations have been stored in memory,
pressing a button from [1] to [6] will enable you
to select a station. (Refer to "Manually storing
stations into memory" on page 41.)

Listening to the tuner

Hold down the [SOURCE/PWR]
1
button for less than 1 second until
the FM/AM mode is shown.
For details, refer to "Switching Audio
Modes" on page 17.

Tuning to a station

There are both automatic and manual methods
(one of each) for storing stations in memory. The
main unit will accept up to 24 stations in memory.
There are 6 stations for AM and 18 stations for
FM (6 each for FM1, FM2 and FM3) (initial
settings).
Press the [ /BAND] button briefly
(for less than one second) to
1
switch to the desired FM or AM
band.
Radio bands will switch from FM1 →
FM2 → FM3 → AM in order each time
the button is pressed.
Tune to a station frequency by
2
pressing the [<] or [>] button.
[>]:
Tunes to higher frequencies.
[<]:
Tunes to lower frequencies.
40
If you hold down the [<] or [>]
button for a little longer time, the
3
device starts to search for stations
automatically.
[>]:
Select higher frequency stations.
[<]:
Selects lower frequency stations.
ATTENTION
At times, it may be difficult to maintain
optimum reception because the antenna
attached to your vehicle is constantly in motion
(relative to the
encountering continuous variation in the
strength of the radio signals received. Other
factors affecting reception include interference
from natural obstacles, buildings, etc.
If the optional HD Radio tuner unit is
connected, digital broadcasts can be received.
(U.S.A. only)

Operations during rotary mode

For operations in rotary mode, see page 18.
broadcast antenna),