Confirm The Ip Address And Test The Audio; Adjust The Volume - CyberData 11061 Operation Manual

2.2.10 Confirm the IP Address and Test the Audio

2.2.10.1 RTFM Switch
When the Paging Amplifier is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch
the Paging Amplifier's IP Address and test the audio to verify that it is working.
Announcing the IP To announce a Paging Amplifier's current IP address:
Address
• Press and hold the RTFM switch for a couple of seconds and then release it.
Restoring the To restore the factory default settings, complete the following steps:
Factory Default
Settings
1. Press and hold the RTFM switch until you hear the Paging Amplifier announce the words,
2. Release the RTFM switch. The Paging Amplifier will be restored to the factory default settings.

2.2.11 Adjust the Volume

There are two ways to adjust the volume for the Paging Amplifier:
•
•
Operations Guide
Caution
Equipment Caution: Pressing and holding the RTFM switch for more than five
seconds will restore the V2 Paging Amplifier to the factory default settings. See
the "Restoring the Factory Default
GENERAL ALERT
"restoring defaults" and "rebooting".
The
Speaker Volume (0-9)
The external Volume dial on the Paging Amplifier face
(Figure 2-18) on the Paging Amplifier face to announce and confirm
Figure 2-18. RTFM Switch
Settings" section.
setting on the Device Configuration page
930324M
Installing the VoIP V2 Paging Amplifier
Paging Amplifier Setup
RTFM switch
CyberData Corporation
18