AMX Modero ViewPoint MVP-8400i Operation/Reference Manual page 75

Protected Setup Page (Cont.)
Docking Station:
Options:
System Recovery:
Reboot / Shutdown:
Channel Code
Channel Port
Level Port
Channel Code
FIG. 51 Function Show example
MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom
• Dock Status - illuminates when the MVP is docked and communicating with
the Docking Station.
• Undock Panel - forces the docking station to release the MVP without
requiring a User Access username or password.
• Disable Docking Station LED - disables the display of the LEDs on the
docking station.
• Function Show - toggles the display of the channel port, channel code, level
port and level code on all touch panel buttons (see FIG. 51).
• Telnet - enables/disables the panel's telnet server (to allow direct telnet
communication to the panel).
• Page Tracking - toggles the page tracking function. When enabled, the panel
reports page data to the NetLinx Master.
• Front Button Setup Access - activates the two lower buttons on the front of
the panel for accessing the Setup and Calibration pages (see FIG. 41 on
page 47). The default setting is On.
- Press and hold these buttons for 3 seconds to access the Setup page.
- Press and hold these buttons for 6 seconds to access the Calibration page.
• Standard Security - This button is blocked out.
• Remove User Pages - allows you remove all TPD4 touch panel pages
currently on the panel, including the pre-installed AMX Demo pages. This
option invokes a Confirmation dialog, prompting you to confirm your selection
before removing the panel pages.
Note that the YES button on the Confirmation dialog is disabled for 5 seconds
as additional protection against accidentally resetting the panel or removing
the panel pages.
• Reset System Settings - deletes all of the current configuration parameters
on the panel (including IP Addresses, Device Number assignments,
Passwords, and other presets). This option invokes a Confirmation dialog,
prompting you to confirm your selection before resetting the panel.
• Reboot - pressing this button causes the panel to reboot after saving any
changes.
• Shutdown - This button will shut down the panel entirely, requiring a manual
restart. This button is disabled when the panel is connected to a power
source such as a docking station, and will only be enabled when running on
battery power.
3,132
BUTTON
2,8 3,50
Address Port
Address Code
Setup Pages
61