AMX Modero ViewPoint MVP-8400i Operation/Reference Manual page 42

Configuring Communications
panel is recognized as a unique USBLAN device, and the association to the driver is handled
automatically.
1. Connect the PS4.4 power connector to the panel (or docking station if the panel is already installed)
to supply power.
2. Press and hold the two lower external pushbuttons on either side of the panel simultaneously for 3
seconds to access the Setup page (see FIG. 11 on page 13).
3. In the Protected Settings page, select System Settings to open the System Settings page (FIG. 25).
4. Toggle the blue Type field (from the Master Connection section) until the choice cycles to USB.
Refer to the System Settings Page section on page 63 for information about the fields on this page.
FIG. 25 System Settings page - USB Connection
5. Press the Back button to return to the Protected Setup page.
6. Press Reboot to save changes and restart the panel.
7. When the panel powers up and displays the first panel page, insert the mini-USB connector into the
Program Port on the panel.
It may take a minute for the panel to detect the new connection and send a signal to the PC
(indicated by a green System Connection icon).
The first time the panel is recognized by the PC as a new USB device, a USB driver installation
popup window (FIG. 26) is displayed. This window notifies you that the panel has been detected as
a USB device, and the appropriate USB driver is being installed to establish communication with
the panel. It also indicates that the AMX USBLAN driver does not contain a Microsoft
signature.
8. Click Yes to proceed with the driver installation.
9. Navigate back to the System Settings page.
28
Once the installation is complete, the panel and PC are ready to communicate via USB.
MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom
®
digital