AMX Modero ViewPoint MVP-8400i Operation/Reference Manual page 17

MVP-8400i Specifications (FG5965-04) (Cont.)
Power Modes:
Battery Duration:
(per battery)
Memory (factory default):
Weight:
MVP-8400i LCD 
Specifications:
Active Screen Area:
External Components:
Docking station interface
connector:
LEDs:
Mini-USB connector:
Power connector:
Stylus slot:
External Buttons:
Internal Components:
Wireless Interface card:
IR Emitters:
Internal speaker:
Internal microphone
Battery compartment:
MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom
MVP-8400i Modero Viewpoint Wireless Touch Panel With Intercom
• ON: Panel is fully functional.
• STANDBY: Panel uses low power, the LCD/backlight is shutdown, LEDs still
function. Panel resumes the ON mode in ~ 1 second.
• OFF: On-board programs not running, touch screen still powered, LED not
functional. Panel resumes the ON mode in ~ 30 seconds.
• Eight hours of normal use (25% On state, 25% Standby, and 50% Off).
• Four hours of continuous use (continuous On state).
The MVP-8400i panel is shipped with two MVP-BP batteries. You must use
both batteries to obtain the duration times given above.
• 128 MB SDRAM
• 128 MB Compact Flash (upgradable to 1 GB) - factory programmed
1.85 lbs (0.84 kg)
• with 1 battery: 2.25 lbs (1.02 kg)
• with 2 batteries: 2.65 lbs (1.20 kg)
• Aspect ratio: 4 x 3
• Brightness (luminance): 180 cd/m
• Channel transparency: 8-bit Alpha blending
• Contrast ratio: 350:1
• Display colors: 256K colors (18-bit color depth)
• Dot/pixel pitch: 0.21 mm
• Panel type: TFT Color Active-Matrix
• Screen resolution: 800 x 600 pixels (HV) @ 60 Hz frame frequency
• Viewing angles (vertical): + 60° / - 40° (from center)
• 6.71" x 5.03" (17.04cm x 12.78cm)
Metallic strip connector located on the bottom panel provides communication
and power between the panel and the optional docking stations.
Two sets of NetLinx programmable LEDs (supporting On, Off, and Blink).
Default blink patterns:
- Stylus LED: Blink = Batteries charging, On = Batteries charged.
- Front panel LED: Blink = Panel booting, On = Panel operating properly.
5-pin mini-USB connector for programming, firmware update, and file transfer.
• 2.1mm barrel-style power jack, for use with the included PS4.4 power supply.
• Illuminated slot where the included stylus is stored, located on the left side of
the MVP.
• Nine programmable pushbuttons (four located on the left of the LCD and five
located on the right in a joystick configuration).
Provides 802.11 (CF Type I) wireless connectivity between the panel and a 
Wireless Access Point (such as the NXA-WAP200G).
Transmit IR over 20 feet (6.10 m).
Single 2 watt speaker.
For use with the intercom feature
Houses up to 2 MVP-BP Power Packs.
2
3